臺式電腦屏幕老是閃爍解決方法 怎么解決臺式電腦屏幕閃爍 Recently opened the computer, the screen will start flashing, a dark one bright, always flashing incessantly, don't know is wrong, also don't know what to do. Is it right? Have many friends and I also encountered the same situation? Look together computer master is how to explain the causes and coping methods.

　　一、電腦剛開機時顯示器的畫面抖動得很厲害，有時甚至連圖標和文字也看不清，但過一二分鐘之后就會恢復正常。這種現象多發生在潮濕的天氣，是顯示器內部受潮的緣故。

　　Float a, just getting on the computer too much, and sometimes even the icons and text are not clear, but after one or two minutes will return to normal. This phenomenon occurred in wet weather, is to monitor http://www.mkykgw.com/ the internal moisture.

　　解決方法：要徹底解決此問題，可使用食品包裝中的防潮砂用棉線串起來，然后打開顯示器的后蓋，將防潮砂掛于顯象管管頸尾部靠近管座附近。這樣，即使是在潮濕的天氣里，也不會再出現以上的“毛病”。

　　Solution: to solve this problem, can be used in food packaging moisture-proof sand string together with cotton thread,http://www.sanbenshu.net/ and then open the back cover of the display, will hang in the damp sand picture tube neck near the base near the tail. In this way, even in wet weather, also won't appear above "".

　　二、你的電源工作不穩定，熱性能不好或抗干擾性能差，導致輸出電壓紋波過大，使顯卡處于無法正常工作的狀態，導致屏閃，此種問題多以熱性能不好居多。

　　Two, the power of your work is not stable, thermal performance is not good or poor anti-interference performance,http://www.jiyinyugen1.com/ leading to the output voltage ripple is too large, so that the card is not working properly, causing screen flicker, this kind of problem in the thermal performance is not good.

　　解決方法：打開電源更換其開關管，濾波電容，或直接換電源。

　　Solution: turn on the power to replace the switch tube, filter capacitor, or directly for power.

　　三、顯示器的行管性能不良，導致高壓過高，屏幕太亮變白成一片，亮度電位器氧化嚴重，阻值變小或接觸不良，電路的故障導致顯示器彩管的加速極電壓過高或陰極電壓過低，都會造成這種電腦屏幕閃爍的現象，特別是初期現象和你現在的問題極其相似。

　　Three, display tube bad performance,http://www.dgfuai.com/ leading to high pressure is too high, the screen is too bright white as a sheet, luminance potentiometer serious oxidation resistance, small or poor contact, the circuit fault leads to accelerated display color voltage is too high or the cathode voltage is too low, will cause the computer screen flicker phenomenon, especially in the initial phenomenon and your problem now is very similar.

　　解決方法：開機等出現屏閃現象，拍打顯示器看現象有否加重(停下來過后的現象，不要用太大的力氣)。加重則顯示器的問題，多是以上部位接觸不良所致，需找專業人士修理，無則不是此處問題。

　　Solution: boot appeared screen flicker phenomenon, beat display phenomena whether increased (stopped after the phenomenon, do not use too much effort). Increase the display problem, is above the site due to poor contact, the need to find professionals to repair, no is not the problem.

　　四、顯卡接口接觸不良，顯卡的熱性能不良，還有顯示器連線接觸不好等。

　　Four, the graphics interface is bad, bad thermal performance of graphics, and display line contact is not good.

　　解決辦法：

　　The solution:

　　1、拔下顯卡，檢查接口是否有銹蝕，用無水酒精擦干凈，同時略把其彈片翹起一些。

　　1, unplug the card, check whether the corrosion interface, anhydrous alcohol wipe clean, also omitted the shrapnel up some.

　　2、等現象出現之后立即關機，用純棉手套或棉布拔下顯卡，用手試顯卡芯片是否過熱(一般是略溫)，過熱換風扇，或換芯片、顯卡。3、用萬用表電阻擋R*1K擋測試顯示器連線是否接觸良好，測試時要晃動著線，其壞的可能性較小。

　　After 2, wait for a phenomenon immediately shut down, with cotton gloves or cloth unplug the card, try the graphics chip by hand is overheating (generally slightly warm), overheating for the fan, or change the chip, the card. 3, using a multimeter resistance gear R*1K gear test display connection is good contact, when testing swaying line, the less likely to bad.