This command shows non-default configurations only. Use 'show config all' to show both default and non-default configurations.
begin ! # ***** NON-DEFAULT CONFIGURATION ***** ! ! #time: Fri Jun 28 2002, 10:53:32 ! #version 6.3(1a) ! set enablepass $2$NR5.$AOW419BA/uWKws9hybQyw1 --More--! #system set system name xxxxxxx ! #! #vtp set vtp domain xxxx set vlan 1 name default type ethernet mtu 1500 said 100001 state active set vlan 3 name servers type ethernet mtu 1500 said 100002 state active set vlan 4 name pix type ethernet mtu 1500 said 100003 state active set vlan 1002 name fddi-default type fddi mtu 1500 said 101002 state active set vlan 1004 name fddinet-default type fddinet mtu 1500 said 101004 state active stp ieee set vlan 1005 name trnet-default type trbrf mtu 1500 said 101005 state active stp ibm set vlan 2 set vlan 4 set vlan 1003 name token-ring-default type trcrf mtu 1500 said 101003 state active mode srb aremaxhop 0 stemaxhop 0 backupcrf off ! #ip set interface sc0 2 10.0.0.249/255.255.255.0 10.255.255.255 ! #set boot command --More-- set boot config-register 0x102 set boot system Flash bootflash:cat6000-sup2.6-3-1a.bin ! #port channel set port channel 1/1-2 1 set port channel 2/1-2 2 ! # default port status is enable ! ! #module 1 : 2-port 1000BaseX Supervisor set vlan 4 1/1-2 set port channel 1/1-2 mode on ! #module 2 : 2-port 1000BaseX Supervisor set vlan 4 2/1-2 set port channel 2/1-2 mode on ! #module 3 empty ! #module 4 : 16-port 1000BaseX Ethernet set vlan 3 4/1-16 --More-- set spantree portfast 4/1-16 enable ! #module 5 : 48-port 10/100BaseTX Ethernet set vlan 3 5/1-47 set vlan 4 5/1-47 set spantree portfast 5/1-48 enable ! #module 6 empty ! #module 15 : 1-port Multilayer Switch Feature Card ! #module 16 : 1-port Multilayer Switch Feature Card end cqyb6506_01> (enable) sess 15
Trying Router-15... Connected to Router-15. Escape character is '^]'.
